VDAOvideo

Wiring Solar Charge Controller to Battery

DavidPoz · 123K views · 7 years ago
Safety check pending
Description

In order to wire the solar charge controller to the battery I need to make custom wires. I'm using an old set of truck jumper wires that are #1 or #2 AWG. The Victron MPPT 250/100 charge controller has 35mm screw terminals. In order to use the flexible cable I need to crimp on a "ferrule" to the wire ends. This is a thin copper tube that slips over the small strands of copper to prevent deforming. I'm also connecting the charge controller to my DC load center. I'm using a 125 amp DC circuit breaker from Midnite Solar. To crimp the ends I"m using a hydroponic crimping tool from Amazon. Detailed video about the Victron 250/100 MPPT Solar Charge Controller: https://youtu.be/Efqx_iRYRjo Hydraulic Crimping Tool: https://amzn.to/2QdnWmx Ferrule Ends: https://amzn.to/2Qi22yz Ring Termi