VDAOvideo

Making Busbars, wiring batteries together, DIY Powerwall (Chevy Volt)

DavidPoz · 34.8K views · 8 years ago
Safety check pending
Description

I'm continuing the build on my DIY Powerwall. Eventually this will be connected to solar panels and an inverter. The off-grid system will be able to supply power even if the grid goes down. In this video I built busbars out of scrap aluminum I had lying around. Then I connected all the batteries to the busbars. The negative leads connect directly; the positive leads are connected to an in-line fuse (30 amps). With the fuse, each battery is protected. Because of the 8 batteries I can draw up to 240 amps (8x30). And, at a nominal 44 volts I can use about 10.5 kilowatts! That's huge! I used the same ring terminals, #10 wire and 1/4" diameter hole. The original bolts I had for this were too short, so I bought some 20mm length m6 bolts. I also used a serrated flange nut to help p